noodleFeet : Goes Metal

I’ve relied on 3D printing for so many of my prototypes lately, and have finally come to a point where plastic won’t cut it any longer. I require metal, in this case aluminum. The likes of which I ordered from McMaster-Carr and received in the mail last week. I literally spent the majority of the weekend meditating over how to measure my cuts and holes… as for the first time in a long time, their accuracy and placement was entirely up to me and my calipers, not some Cartesian goo plotter as I’m so spoiled by…

While everyone was downing beer and watching the Stuperbowl, I was in the garage with Mark playing with his father’s ancient drill press. He eyeballed one axis, I checked it against the other, and we were able to punch the 24 holes needed on the four pieces of aluminum tubing which would soon be noodleFeet’s strong new legs.

noodlefeet bones

As you can see, I printed out little strips of paper with lines where holes needed to be drilled. It only occurred to us immediately after we finished how much easier this would have been if we had 3D printed a jig for drilling the holes instead… So alas, 3D printing could have potentially saved the day. Thoughtful or not… we did a pretty good job.

Once the aluminum femur was assembled, I realized I was going to need stronger springs. These flour legs are going to support eight motors, a board, and eyeballs; a decent amount of weight:

noodlefeet legs baby

The calf bit is essentially a bone buried within the noodle material. However, with my last prototype, the bone kept sliding out the clearance slot I cut in the noodle. So to remedy this I made these little braces that look like pac-man heads… which keep the bone centered within the tube and prevent it from popping out where it isn’t suppose to:

noodlefeet shin braces meat bones

The rare and beautiful white noodle was harvested by Mark from the great noodle beast itself. I cut the pieces to length with a Japanese saw and carved the appropriate clearance slots so that the legs can fold in on themselves like they should:

noodlefeet noodle meat

The new servo and leg bracket is THICK. It is complete with roller bearings spaced a decent amount apart vertically to keep the intersecting pipe from wobbling around (as with my first prototype):

noodle pelvis

The eight roller bearings hold the pipes perfectly parallel to one another and allow them to turn nice and smoothly. I also added stronger springs to tension the legs outward, so the new prototype is a little monster. Although… he looks sort of helpless up-side-down on my bench right now:

noodlefeet assembly

At this point, Feet is nothing but a pile of feet. He needs eyes, and that is exactly what I’m going to do next… and maybe a brain. Over this weekend I’ll likely hook an Arduino up to his servos and figure out a walking pattern too.

I honestly have no idea what it’ll look like when he walks, but I’m hoping due to the springs counterbalancing his weight that he’ll have a little bit of a bounce. That’d be cute.

I also don’t know if he’ll be able to balance himself when he walks. Once summer happens and the noodle is less rare, I will go harvest some 4″ stock (in neon yellow) from Walmart and cut my prototype some new fat feet. That way he makes more contact with the ground and is less like to fall. Like training feet.

noodlefeet first assembly

Hopefully by my next update he’ll be moving some… like a robot aught to. Cheers!

Be the first to comment

Leave a comment

Your email address will not be published.


*


%d bloggers like this: